454 Headers for 60-66 Chevy Truck? Anyone out there make them? ???

Here is one for the fabrication guys: What equipment is needed to fabricate a "Pittsburgh Seam" in sheetmetal? These seams are typically used in...

I have a question hopefully you all can help with concerning torsion bar front suspension on an early dodge dart. I picked up a 64 dart wagon that...

i need to get a drivers side axle shaft for this ford 9in from a lincoln versailes. anyone know where i can find one? or the length or it? its the 28...

Hi, someone please help me, I am a carb idiot and just can't figure out my problem. I have a ZZ4 350, TrickFlow heads 2.02 1.60, A comp cam .474...

i got the vacuum leak fixed but in the process of having idle problems, i messed with the throttle stop screw. does any body know how many turns from...

Does anyone kow where I can get an aluminum dash for my duster? I have seen the one in Jegs book, it has only a 5" face. I would like to have one a...

I just picked up a few parts for my ranger drag truck. 8.8 axle from a ranger to replace the 7.5 in it now, and a C4 trans from an older mustang...

The 67 Malibu I drive has starting issues, and I believe it to be something in the wiring under the dash. I hate trouble-shooting wiring; I know very...

Can someone give me a quick rundown on the allowed body mods for the subject line class. Without an actual rule book, the best I can do is; original...

I don't see anywhere in the rulebook where it states that a Production car needs to have any portion of the stock frame or floorpans in place....

After reading a post by Shaun Callaway in the Swap Meet section, I started pondering TorqueFlites. How difficult would it be to build a...

Does anybody out there have any info. on swapping a late 5.0 Mustang motor into last gen (2001) F-150 short bed? I can't be the first person who has...

wondering if anyone has a little trade secret to use a s10 t5 trans that has an electric speedo sender with a mechanical cable speedo? the s10 trany...

I heard that Kaase was building a new street version of the Boss 429 heads. I looked on his website the other day but didn't see anything. Does...

I'm not one... but theres a couple of tools in my shop that resemble machine tools... anyone else in here enjoy making parts on a milling machine or...

I was making a high speed hard stop to finish bedding in the new Bear brakes I installed on the car when BANG! it pulled hard to the right and even...

I've got a 350 with vortec heads, edlebrock eps manifold, AFB carb and HEI distributor and when running through the gears about 3500-4000 it starts...

Help Need to know what should the be the correct preload on used pinon bearings. New bearing is 25"lbs but not sure with the used normally it's...