My 1950 Buick Sedanette Project - (pic heavy)

[1950_Buick]

A couple of shots from the back... air tanks in place, had to cut and sleeve the hoop for proper clearance...

also need to replace the truck oil pan for a lower profile one

[1950_Buick]

3 1/2 inches need to be cut from the left side of the 9"

[SuperBuickGuy]

now you have the same length axle shafts?

[1950_Buick]

no, it will be closer for sure, but still slightly staggered, just not as much

[Deaf Bob]

Rear from a van?

[1950_Buick]

truck - putting a new pumpkin in it

[Criscobath]

Cool build.

[1950_Buick]

Cool build.

Thanks!

[1950_Buick]

work has been on a hiatus lately, but here's a couple more pics...

[Deaf Bob]

Getting there!

[1950_Buick]

Temporarily moving locations with some oddball wheels, however liking the lowered look - this is the bags at their highest clearance... this thing is going to sit nice and low!

[SuperBuickGuy]

you certainly are getting me enthused about getting back on mine. I'm 99.9% sure that I'm going to run mine looking like a crapbox for at least a couple years (finish the suspension, motor, and floorboards but leave the outside alone).

[1950_Buick]

you certainly are getting me enthused about getting back on mine. I'm 99.9% sure that I'm going to run mine looking like a crapbox for at least a couple years (finish the suspension, motor, and floorboards but leave the outside alone).

I hear ya... my bank account says the same thing... i'm just hoping that i have enough there just to finish the driveline and get it running!

[1950_Buick]

I just ended up buying this tonight... shipping to me tomorrow

9 inch N case strange pinion support and yoke. Mark Williams 35 spline spool with richmond 28 spline 3.70 gear.

(Racepac sensor not included.)

[Deaf Bob]

28 fits into 35, but don't mesh...
I must be reading wrong?
35 spline spool with 28 spline axles?