Originally posted by silver_bullet
View Post
Announcement
Collapse
No announcement yet.
Plastic Fantastic tew
Collapse
X
Collapse
-
By short studs, i am referring to 1 to 1 1/2 " that would replace the existing bolts that hold the slider frame to the body of the car... our storeroom used to stock long set screws with provisions for using an allen wrench for installation... when we would get in a tight spot, we would use them with shoulder nuts to make for easier alignment of the hardware and reducing the possibility of cross threading...Last edited by silver_bullet; July 16, 2021, 05:36 PM.Patrick & Tammy
- Long Haulin' 2008, 2009, 2010, 2011, 2012, 2014...Addicting isn't it...??
- Likes 1
Comment
-
time to make the seat, shorter
first, will I get the seat out with the top on?
yep
first seat, I did more work then I needed... it doesn't need to come apart
simply take the hog rings off the front and back - and the pad just comes right out
chop chop
gently take the cover off - it's glued to the foam but comes apart fairly easily
and mark 1" all around
handy tool for shaping foam
slide the foam back in (this is the driver's seat)
clip back into place with hog rings then close the bottom cover
and voila, you have another 1". If you don't use the Corbeau brackets and simply weld in 1" 1/8" strips between the rails - you can save both money and gain another 1/2"
tip is pay attention to what you're welding to
you may want to eliminate the bolt where the lever is - otherwise it holds the lever over and the seat won't lock.... and the best of all, is I now fit with my helmet (though in most cases, I'll leave the top off and run it without the rear window like a targa.... cooler and I'm not hitting the roof.... but if I have to, I can fit with the top on.
In other news, the heater line mods (changed the block to vacuum to open rather then open unless vacuum) has done wonders about keeping the interior more comfortable...Doing it all wrong since 1966
- Likes 1
Comment
-
-
Originally posted by Deaf Bob View Post
Up in your area?
Doing it all wrong since 1966
- Likes 2
Comment
-
Comment