These are good guys, I know some may wish Tacoma wasn't in the US, but it is and they manufacturer there. They're also one of the few that will regrind your cam.
Been bragging on Delta Cams for some years. I ran them in my 25-" Chevy sixes and had great success. They're also great folks to work with, friendly and helpful on the phone and when you call you don't get an endless phone tree.
ok, i have FINALLY jacked it up, put it on stands, and removed the 2 front
tires in prep for removal of stock front suspension/straight axle conversion.
lets hope its just a day or two and not a week/month/year or two before
i get on it again.
ok, i have FINALLY jacked it up, put it on stands, and removed the 2 front
tires in prep for removal of stock front suspension/straight axle conversion.
lets hope its just a day or two and not a week/month/year or two before
i get on it again.
YAAAAAAAAAAAAAAAAASSSSSSSSS i beat it by a month, it was less than a year!!!
FINALLY stripped stock front suspension off in prep for the straight axle swap. finally!
trying to keep the momentum going...... yes !!
just mocked up, but i got lucky and the front
spring hanger has 2 holes to rosette weld for install--
and one happened to line up with a bumper bracket
hole in the frame.
im CERTAIN that the factory frame holes and speedway
machined holes in bracket are WAY more accurate
compared to my measuring, marking, and drilling.
a 3/8-16 bolt, couple hardened washers and a nut
on each side positively locates both springs pretty
much dead nuts even. yay! more to follow.......
my neighbor donald had a manual protracter/angle finder. i had a bubble level.
between the 2. i rolled kingpin housing back 10 degrees (to compensate for
when iron head rat motor goes in...) and tacked the axle in place....
heres hoping the magical brown truck of happiness shows up with spindles &
kingpins tomorrow......
got the kingpins/spindles installed today. to say it was "interesting" iis an understatement....
ill put up some pics when my younger boy fwds them to email.
no, i dont know how to do that myself.
shut up.
Comment