Yamaha IT175K

[DanStokes]

You turned me onto that crane scale. I always thought they were maxibux but it was pretty cheap and I've used it more than I thought I would. A nice thing to have in the shop!

Speaking of which, I have an HHR transmission to weigh.

[BBR]

I decided to weigh it. This is 100% dry

[BBR]

A few pics!

[BBR]

[BBR]

Intake and carburetor installed but got roadblocked by the 40 year old fuel line!

[BBR]

Exhaust, spark and plastics! Looking like a dirt bike again!

[BBR]

I finally button the bottom end up! Everything is looking good!

[BBR]

Added the lighting coil to the new stator and installed it.

[DanStokes]

Showing my ignorance!

Marley in Dicken's A Christmas Carol. A classical allusion (that I only know from the movie). He comes back from the dead to try to scare Scrooge out of being a - well - Scrooge.

[BBR]

"These are the chains I forged through life". OK, a challenge. Who said that?

Showing my ignorance!

[DanStokes]

"These are the chains I forged through life". OK, a challenge. Who said that?

[BBR]

I'll give it a whirl. Thanks!

[65RHDEER]

I cut it 2 links too short. I counted the existing chain, but really should have looked at the service manual. It states 103 links and i cut this one to 101.

Where the chain is running over your Workmate, it's being pushed up to the swingarm, take that deviation out and you should be able to get the link in.

[BBR]

Did you work out your chain problem, I can see it...

The chain is the correct length.

I cut it 2 links too short. I counted the existing chain, but really should have looked at the service manual. It states 103 links and i cut this one to 101.

[65RHDEER]

Did you work out your chain problem, I can see it...

The chain is the correct length.