I ordered a new 4an braided line from AllStar. It should be a higher quality line and has AN fittings kn both ends.
Just for fun I opened up the MSD. I noticed the solder by a diode looked as if it has been hot. So, I pulled the board out and sure enough, there was a burnt trace. I will solder it back, touch up a few joints that look cold and see if it will power up.
Just for fun I opened up the MSD. I noticed the solder by a diode looked as if it has been hot. So, I pulled the board out and sure enough, there was a burnt trace. I will solder it back, touch up a few joints that look cold and see if it will power up.
Comment