Always wanted a set of scales so I knew how much weight I was adding etc.
This is the 427 truck and it includes the parts in box. Full interior less bumpers and exhaust, no fenders or inner fenders. I was hoping done would be under 3600 lbs
It did not work out so well as did not like the "look" of it.
By cutting out sections of a extra '66 cowl piece I felt these ends would make it better. Still a lot going on with all the curves and might look a bit out of place but at least it will allow
for room of the HVAC assy and also more room for dash stuff
Using the template I made I then took a piece of .083 1" tubing in a 10' length set it up on a couple blocks and stood on it to start the arch in the 2 different directions needed.
I then moved onto the cheap HF 20 ton press and used a Osha approved method in getting the curved shape to fit cowl. LOL
Comment