so circumstance would have it that a freshly rebuilt t56 has fallen out of the sky into my lap. It was rebuilt for a 454 and it has an LS input shaft. Everything fresh though and I have a build sheet to prove it.
Anywho, what will I be needing to swap from a t350 to the tremec. I have a bell and adapter for the 454 because this is an srt10 truck trans.
Shifter
Hack the trans tunnel
special speedo cable for electric to mechanical
driveshaft
pedals
Rods
linkage
am I on the right track here?
Anywho, what will I be needing to swap from a t350 to the tremec. I have a bell and adapter for the 454 because this is an srt10 truck trans.
Shifter
Hack the trans tunnel
special speedo cable for electric to mechanical
driveshaft
pedals
Rods
linkage
am I on the right track here?
Comment