I want to rehook up the downshift switch, or passing gear switch, on the Caprice's TH400. It's basically a push button switch that is activated by the carb linkage opening to full throttle.
There are two wires that connect to the trans. An orange and a black, I think. The plug and switch have four terminals, but for the life of me I can't figure out where the other two wires are, if there are any. And, which of the terminals the two wires from the trans go. The wires came out of the terminal connector and I don't know how where they go.
Here's a pic of the switch with it's terminal markers. With the button out, the SW post and REL post are connected. With the button push in the IGN and SOL posts are connected.
There are two wires that connect to the trans. An orange and a black, I think. The plug and switch have four terminals, but for the life of me I can't figure out where the other two wires are, if there are any. And, which of the terminals the two wires from the trans go. The wires came out of the terminal connector and I don't know how where they go.
Here's a pic of the switch with it's terminal markers. With the button out, the SW post and REL post are connected. With the button push in the IGN and SOL posts are connected.
Comment