I need to pull the 3rd member out of a '62 Imperial. I know I have to use a hub puller to get the drums off but do I need any special tools to remove the axles? I seem to remember reading (I think in an old Mopar Muscle) that on an early A body rear you could replace the axle shafts and brakes with the later (66 up?) pieces. Anyone know if I could use the brakes off a '68 New Yorker, and if the housings are the same width axles too?
Announcement
Collapse
No announcement yet.
Early 8.75" Mopar rear ends
Collapse
X
-
Re: Early 8.75" Mopar rear ends
Imperials from that era are kind of strange, with the 5.5" bolt pattern, etc. So I would not make any guarantees. But in general, the housing ends are the same.
My fabulous web page
"If it don't go, chrome it!" --Stroker McGurk
Comment
Comment