Tweet
Hi-I,m new to this forum-just discovered it yesterday. I would like to know if anyone has a tip on installing the red rubber check valve in a holley accelerator pump. I think it is supposed to be pulled through the little hole from the bowl side but it seems rather fragile-like it wants to tear. Any suggestions would be greatly appreciated-thanks! Chuck
-
-
Re: Holley accelerator pump question
Yes, it just pulls through. Use a pair of tweezers or a small needle nose pliers. Spray a little WD40 on it to make it go a little easier, or use a tiny bit of Vaseline.
BS'er formally known as Rebeldryver
Resident Instigator
sigpic -
Re: Holley accelerator pump question
trim the nipple off when done, did I just say nipple LMAO :o2007 SBN/A Drag Week Winner & First only SBN/A Car in the 9's Till 2012
First to run in the .90s .80s and .70's in SBN/A
2012 SSBN/A Drag Week Winner First in the 9.60's/ 9.67 @ 139 1.42 60'
2013 SSBN/A Drag Week, Lets quit sand bagging, and let it rip!Comment
-
Re: Holley accelerator pump question
Yes! Trim your nipples or they can hang up your float.Comment
-
Re: Holley accelerator pump question
I hate it when my float gets hung up on my nipples!!Originally posted by Eric68Comment
-
Re: Holley accelerator pump question
Car porn you have to love it LOL :
2007 SBN/A Drag Week Winner & First only SBN/A Car in the 9's Till 2012
First to run in the .90s .80s and .70's in SBN/A
2012 SSBN/A Drag Week Winner First in the 9.60's/ 9.67 @ 139 1.42 60'
2013 SSBN/A Drag Week, Lets quit sand bagging, and let it rip!Comment
Comment