So I'm building a tube chassis car and it's almost time to mount the motor and tranny and with the motor close to sitting where it needs to be I notice the trans output will be about 1.5 inches below the pinion of the rear end. This is a 4-link car with a dana. I put 2* of pinion angle in in the rear but it looks like it could use a little more. A little advice from the experts would be appreciated.
Announcement
Collapse
No announcement yet.
drive line angles
Collapse
X
-
Re: drive line angles
2 is a lot if its a stiff 4 link car. 1 on the small end 2 on the big end thats the range I use2007 SBN/A Drag Week Winner & First only SBN/A Car in the 9's Till 2012
First to run in the .90s .80s and .70's in SBN/A
2012 SSBN/A Drag Week Winner First in the 9.60's/ 9.67 @ 139 1.42 60'
2013 SSBN/A Drag Week, Lets quit sand bagging, and let it rip!
Comment
Comment