Ok 350 COMBO 375-400 HP

[ZZTOP]

Here is the question 73 350 from a z28 angle plug heads
What combo would You guys Use to achieve the 375-400 HP range

Thanks for any help

Of Course The Block is NON ROLLER

[Freiburger]

Re: Ok 350 COMBO 375-400 HP

I think it will be hard NOT to make that power. 375 hp from a 355ci mill is 1.07 hp/ci. I'd do a small amount of bowl blending, three-angle valve job, 9.5:1 compression using SRP flattops with 1/16-inch rings, 230-at-0.050 hydraulic flat-tappet cam on a 110 LSA, 1-3/4 headers (Tri-Y if you can get them) and an RPM Air Gap intake with a 650 Holley.

[std]

Re: Ok 350 COMBO 375-400 HP

+1 with more compression if you can get it.

[Freiburger]

Re: Ok 350 COMBO 375-400 HP

I was assuming guaranteed ping-free.

[std]

Re: Ok 350 COMBO 375-400 HP

I was thinking don't worry if the compression comes out a little higher.

[Freiburger]

Re: Ok 350 COMBO 375-400 HP

OK, yeah...9.5, 9.8, whatever.

[std]

Re: Ok 350 COMBO 375-400 HP

I didn't like the way my post sounded after i read it. Seemed a little snotty.
What i'm trying to say is if you measure everything up and it's 10.2, I wouldn't do anything to change it.

[ZZTOP]

Re: Ok 350 COMBO 375-400 HP

Thanks for the combo info