I know Scott would never believe that I am asking this LOL but I think there is a time where fuel injection is absolutely the way to go. I think this is one of them. Here is the combo -- it is important to note that this engine will be run on E85 ethanol, not race gas!
377" SBC -- 4" bore x 3.75" stroke
AFR 210 Eliminator heads
Edelbrock Victor Jr manifold
Comp custom solid roller: 248-260* @ .050 on a 113* LSA, .630" lift
9.2:1 static compression ratio
ProCharger F1R, non-intercooled, but has fogger nozzle in outlet of blower spraying E85 for cooling at WOT.
24 psi of boost at 6,000 -- expect closer to 28 PSI at 7,000
This combo put down 848 RWHP at 6,000 RPM (should make a ton more at 7k) with a carb before torching a piston. We had a lot of timing pulled out with a MSD 6btm but the carb went lean on us. I don't think we can get enough fuel through the needle and seat to keep it fat at high RPM.
Sooooo . . . . .
I am thinking Big Stuff 3 with 16 injectors. The thing though is that I am not an EFI guru and am estimating 160 lb/hr worth of injectors is needed. Probably a set of 96# and a set of 65# ????
Any thoughts on this? I am open to any suggestions on injectors, controllers, etc since we are starting pretty much from scratch here.
377" SBC -- 4" bore x 3.75" stroke
AFR 210 Eliminator heads
Edelbrock Victor Jr manifold
Comp custom solid roller: 248-260* @ .050 on a 113* LSA, .630" lift
9.2:1 static compression ratio
ProCharger F1R, non-intercooled, but has fogger nozzle in outlet of blower spraying E85 for cooling at WOT.
24 psi of boost at 6,000 -- expect closer to 28 PSI at 7,000
This combo put down 848 RWHP at 6,000 RPM (should make a ton more at 7k) with a carb before torching a piston. We had a lot of timing pulled out with a MSD 6btm but the carb went lean on us. I don't think we can get enough fuel through the needle and seat to keep it fat at high RPM.
Sooooo . . . . .
I am thinking Big Stuff 3 with 16 injectors. The thing though is that I am not an EFI guru and am estimating 160 lb/hr worth of injectors is needed. Probably a set of 96# and a set of 65# ????
Any thoughts on this? I am open to any suggestions on injectors, controllers, etc since we are starting pretty much from scratch here.
Comment