i found an lq4 6.0 with the trans, wiring harness and ecu all for sale on craigslist. could i just put this in the monte the way it is since i'd have everything? or would i still have to get it tuned? what else would i have to do other than mounts and driveshaft lengthening/shortening?
Announcement
Collapse
No announcement yet.
EFI LQ4 6.0 in my monte
Collapse
X
-
EFI LQ4 6.0 in my monte
formerly 1988montecarloss, 3198 posts
http://bangshift.com/forum/member.ph...88montecarlossTags: None
-
Itll run fine, just not the most performance. Swap it in. It'll run, at worst you'd have to mess with the VATS. Id save for a tune, you can drop a full second in the 1/4 on a stock motor. Only thing Im not sure about is how the 80e will fit your tranny tunnel. Id trade you a 60e if you was closer. you can make it work thou.Si vis pacem, para bellum
-
ive already done the floors in it once haha, so making the trans tunnel bigger wont be a big deal. but how much wiring am i looking at? should i just be able to hook up everything that it comes with and run it or am i gonna have to do some splicing into the chassis harness in the monte too?formerly 1988montecarloss, 3198 posts
http://bangshift.com/forum/member.ph...88montecarloss
Comment
-
Comment