Blade sealing secrets
Kevin,
Why Thanks!
Xjs12... The Jensen's arch nemesis...
If youve got a lathe, whip up a 5 deg turning fixture (couple of precision rods inserted into a round (smaller than the blades but bigger than the two-bolt pattern...) that has the 5deg angle at the correct orientation. Drill and Rough cut the blades (or have them punched if you're making a lot) and spin em down on the lathe to the exact needed dia. (at the 5 deg angle) Sure shot... Our non-round blades are cut on the mill and are much more problematic sealing wise.
Kevin,
Why Thanks!
Xjs12... The Jensen's arch nemesis...
If youve got a lathe, whip up a 5 deg turning fixture (couple of precision rods inserted into a round (smaller than the blades but bigger than the two-bolt pattern...) that has the 5deg angle at the correct orientation. Drill and Rough cut the blades (or have them punched if you're making a lot) and spin em down on the lathe to the exact needed dia. (at the 5 deg angle) Sure shot... Our non-round blades are cut on the mill and are much more problematic sealing wise.
Comment