While doing some research into my eventual swap to EFI, I have a couple of questions. I have a Mallory Promaster billet distributor (hall effect) feeding a Mallory 685 control box. Currently, I hook the distributor into the green and purple wires on the 685. To supply the RPM signal to the MS1 (version 3.0), I am not finding much info that is Mallory or 685 specific. I have found that the MSD 6 using a hall effect is rewired so that the distributor wires are fed into the MS on pin 24 and pin 37 feeds the MSD 6 on the white wire. Will this be the way I need to wire my Mallory?
I am going off of this section in the Megamanual:
Also, I bought the MS1 prefabbed from DIYAuto about 10 years ago (not one to rush into anything ). The instructions on the Megamanual says to follow steps 50-52 in the assembly manual. How much of this was done when it was made and how much do I need to go back and do?
Thanks.
I am going off of this section in the Megamanual:
Also, I bought the MS1 prefabbed from DIYAuto about 10 years ago (not one to rush into anything ). The instructions on the Megamanual says to follow steps 50-52 in the assembly manual. How much of this was done when it was made and how much do I need to go back and do?
Thanks.
Comment