Powder Coating Leaf Springs

[cstmwgn]

boB - we are getting there - still a little short for the full year but they are only charging my card monthly so there is time to fill it all in....

[cstmwgn]

OK, I have setup the monthly deliveries - the delivery costs were a little higher than I expected so if anyone is still interested in contributing, please...

[cstmwgn]

Just another failed attempt at humor on my part....

[cstmwgn]

WOW - I never thought about moving the front suspension forward to gain engine setback ...

[cstmwgn]

Yes - when we are talking LOBE lift! ...

[cstmwgn]

Were doing the Gilmore...

[cstmwgn]

Dave - check your email. This early registration was for last years participants. I believe you registered and were not able to attend so you might just...

[cstmwgn]

Well, there may be some difference in the enjoyment level between watching and doing!...

[cstmwgn]

I must have missed the part where he was joining the teamsters!
Yes he is moving but it didn't sound like he was going nomadic.
...

[cstmwgn]

My experience is that Comp's recommendations are VERY conservative.

[cstmwgn]

Soooo, being the contrarian that I am, if your going to run a high stall - you need to run a BIG cooler and man up!

[cstmwgn]

test what?

[cstmwgn]

I was hoping you would see this - so IF in fact he only puts the leafs in for 30 minutes and they don't actually get over 350 degrees - does that mean...

[cstmwgn]

Thanks for all the input.

I got an answer from the powdercoater that while their ovens do run 400* that the parts are only in about 30 minutes...

[cstmwgn]

I was very happy to help in any way that I could. Greg was a great guy that was always enjoyable to be around.

For anyone that would still...

[cstmwgn]

Yeah - I read that too. In fact the guy from Eaton that did that earlier article also stated that unless the liners were made out of Delrin(sp) that...

[cstmwgn]

Break that checkbook out as you can buy every single part new today!...

[cstmwgn]

Thanks Patrick - I found that article earlier today AFTER I had dropped of my disassembled springs at the powdercoater! As with most stuff on the internet,...

[cstmwgn]

OK, so I know we have at least one expert on powder coating and several others with mounds of experience.

Is it a mistake to disassemble...

[cstmwgn]

Lars - I an a visual guy! Who the heck actually reads the message?