Announcement
Collapse
No announcement yet.
Search Result
Collapse
500 results.
Keywords
Members
Tags
-
Also watching for inexpensive something for my/my sons' new to us EconoCrapBox Mazda3 that's pretty noisy inside.
-
Volvo S6R/V70R are the most comfortable seats I've ever put any miles in. I've not put a lot of miles in the W140 Coupe seats I have in the Riviera but...
- Likes 1
Leave a comment:
-
My '64 Riviera has a two piece shaft with a carrier bearing in the middle. I'm not sure if it's a luxury or a need to work with the X-frame (not the...
Leave a comment:
-
Our High Explosives transport flatbed has 4x4's between the frame and the bed. Grounding is required so it's not a choice they made for isolating the...
Leave a comment:
-
The revised oiling passage 4.1's are 1984 only (which that one is) but in general 4.1's are 1980-1984 only and a relative minority of Buick V6's even...
- Likes 1
Leave a comment:
-
Is there room to use the rack mounting points to put a brace/spreader in there so the chassis loads have a load path higher up since you've cut most of...
- Likes 1
Leave a comment:
-
-
Good point about needing to bush the lifters anyway (Buick V6's have bad core shift on the #3 Exhaust bore) and being an LSR application restricting the...
Leave a comment:
-
Rusty Block: Salvagable?
Howdy y'all
Been poking around for a block to replace one of my project Buick V6's and found this lingering on eBay.
...
-
Good thing I have access to a University Library!
I bought the Puhn book but I'll check out the Adams book to see what I think as it's ~3x...
Leave a comment:
-
What do you think of the Herb Adam's book Chassis Engineering?
Leave a comment:
-
https://www.amazon.com/How-Make-Your.../dp/0912656468
Just added it to the shopping cart though I might try eBay for a used and not...
Leave a comment:
-
I'd take a tip from the diesel guys and cut what you have into individual sections with a saw or cutoff wheel to keep the thermal expansion in the flange...
- Likes 1
Leave a comment:
-
My tip on pulling doors is to buy new fasteners that way when you’re good and done you can take the rattle out. Even the reusable ones sometimes...
- Likes 2
Leave a comment:
-
Send-Cut-Send is a worryingly easy way to get stuff done!
- Likes 1
Leave a comment:
-
TANGENT ALERT!!
I just got a Mazda3 from my sister for my boys to spruce up in the few years till the oldest can drive. Be happy to measure the...
Leave a comment:
-
The Seat Shop came highly recommended by the local upholstery people for truck seat covers. $250ish for a section is expensive but they're amazing fit...
- Likes 1
Leave a comment:
-
I've done work!!!
The headlights are in with relays so the H4 bulbs can get a better power supply as well as I changed out one of the harnesses...
- Likes 1
Leave a comment:
-
When I did mine I cut a 1/2in wide brush down to about 5/8-3/4in of brissels which I kept dipped in acetone to smooth the surface out but to put it on...
Leave a comment:
-
That tire swap was so worth the $265 it cost me!!! I traded out the Load Range E Wrangler Ultraterrain AT with Kevlar that came on the RWD (even the...
Leave a comment:
Leave a comment: