Dickies

[langleylad]

I don't know about you all but I love my Dickies work pants . As many of you know they are as stiff as 22 gauge steel sheet when brand new . Again many...

[langleylad]

So it’s been a little while since I updated on here. I needed two items before I could fire this thing up for the first time with this combo. The...

[langleylad]

This weekend I installed the factory air dam. Which of course had to be modified to fit and I started to disassemble the front suspension for a good cleaning...

[langleylad]

Very nice ! that should do the trick ......

[langleylad]

Snazzy !...

[langleylad]

You’re darn toot’n ! ...

[langleylad]

Today’s project was to get the dash ready for a Holley 7” Digital Dash . I could spend $300+ for an aftermarket piece but why do that when...

[langleylad]

It is enjoyable spending somebody else’s money 💰...

[langleylad]

For paint and grade 8 fasteners .... yes . Speed parts .... not so much ...

[langleylad]

These new fangled plastic intakes are the cat's pjs . The vacuum ports provided will not work because of the close relationship to the hood. The intake...

[langleylad]

For a Dirty White Boy you do some mighty clean work

[langleylad]

This truck scooted along nicely with the 4.3 V6 , this new combination should be a handful

[langleylad]

It's coming along ...

...

[langleylad]

Figures it would be you to call me on that ! 🤣
Yes , you are correct. I meant PCV
Thanks for paying attention...

[langleylad]

My latest project was to set up a catch can/ PVC system . Going through my AN fittings I found a couple of GM fuel line adapter fittings . I drilled them...

[langleylad]

Now that most of the fabrication is done I can take it apart and make things pretty. I needed to finish welding a section of the frame , clean and paint...

[langleylad]

If you're looking for molded hoses for your swap , here's a great guide

https://www.gates.com/content/dam/ga...wledge-center/...

[langleylad]

Inches do matter , I remade my crossover pipe just to gain an inch , extended the front bumper mounts to gain 3/4 inch , repositioned the rad , and clearanced...

[langleylad]

I find the better I get at tig welding , the more time and money I save on grinding…...

[langleylad]

The direction I’m heading …. Those won’t be necessary ...