User Profile

[Russell]

I like to call it Analysis Paralysis!

[Russell]

The underside of a 5.8L GT40 intake manifold with bad gaskets....

The text was about the truck in general. I swept the bed of the truck,...

[Russell]

Pic...

[Russell]

I have not washed it yet. I have swept out the back. Got the trash out of the inside and vacuumed it out. Then I parked it under a persimmon tree....

[Russell]

I have to decide what I am going to do with the lighting before it gets a thread. I figure I can just mix it in here. Not alot yet. Next week I hope...

[Russell]

The turbine exit square to the FED. Parallel to the crank....

[Russell]

I am proud of my bracket, but very few numbers and no calculations where used in the making. So I would call it custom fabrication! I have been around...

[Russell]

Got the lower off the gaskets had been replaced before, they were bad. Pressure washed the intake.
Made a bracket to mount the turbo where the power...

[Russell]

Dan's mustang is not stock it has HCI 5.8 people have gone very fast on 4 lugs so I still think it should be ok....

[Russell]

Unless the 5 lugs plus all the parts to switch it over are cheaper tht the 4 lug wheels you picked out I would keep it 4 lug.

I am #4lug4life!...

[Russell]

I have been splitting my time between mustang and the lighting. I got the upper intake off of the lighting, and the h-pipe off the mustang it's much easier...

[Russell]

ADD : Another Dumb Decision ADD : Another Durn Distraction
15 weeks until Drag week let's buy another project!

1993 Ford Lightning!...

[Russell]

I made some brackets to mount the intercooler. Ground down the head of 1/4" bolts and drilled out the header panel some and glued them in. I did...