OK, so I am in the final throws of wiring now. Running 8 injectors above the blower only.
1. Thinking about running the injector driver leads to a terminal strip first where I will join 2 injectors together and then send one wire from each pair from the terminal strip to the JP1 on the relay board. No need to do the same for the 12 volt power leads is there? Using 16g leads although I know thats overkill.
2. Polarity not an issue on the wires from the injectors is it? Just a circuit?
3. Running grounds from each sensor to the respective locations on the relay board. Do I need to do anything regarding pin 19? Manual is confusing on this issue?
ed
1. Thinking about running the injector driver leads to a terminal strip first where I will join 2 injectors together and then send one wire from each pair from the terminal strip to the JP1 on the relay board. No need to do the same for the 12 volt power leads is there? Using 16g leads although I know thats overkill.
2. Polarity not an issue on the wires from the injectors is it? Just a circuit?
3. Running grounds from each sensor to the respective locations on the relay board. Do I need to do anything regarding pin 19? Manual is confusing on this issue?
ed
Comment