3800 v6

[65RHDEER]

There was a fault found in another video of the tear down of Kevin's old motor, broken ringland on one cylinder.

New Kev on the dyno.

[65RHDEER]

Richard back to playing with a 3800

[SuperBuickGuy]

Richard back to playing with a 3800

I want to like him, he plays with much the same stuff I do... but all I want to do is punch him in the nose. I know, I know, not very nice (and isn't going to happen, even if I meet him)... but still, he owes me several monitors and keyboards because he is proof positive that smarts cannot be gained by being around smart people (Westech).

[65RHDEER]

[SuperBuickGuy]

Tim is snoozing... no seriously, it's got to be midnight there

[65RHDEER]

Tim is snoozing... no seriously, it's got to be midnight there

It was about 7AM Friday here when that went up.

[65RHDEER]

Do you want to watch a V6 being put in a car, there are no surprises here...

[SuperBuickGuy]

Do you want to watch a V6 being put in a car, there are no surprises here...

that same, dumb tube is on the motor I'm putting in the Fiat Spider....

[65RHDEER]

New motor goes to the Dyno

[65RHDEER]

It's a long one with a not so good result

[Beagle]

I'd like to see the heads and cam go into the other 3800 he has using whatever to make it run and see if it spits out bearings at 6400 too. I get it, paying to resize rods and a 100.00 set of rod bolts kind of defeats the purpose of 300 dollar junkyard mills.

[65RHDEER]

Rich is playing 3800 again, I think he read your post Beagle!

[SuperBuickGuy]

I'm so tempted to use a 3800 in the Fiat.

[65RHDEER]

I'm so tempted to use a 3800 in the Fiat.

Dare to be different!

[65RHDEER]