Changed the settings from 36 tooth wheel to distributor, the tach guage works fine now and the fuel pump light comes on and stays on when it should.
The WarmUpEnrichment guage is a bit wonky...... keeps dropping till it goes off the chart and goes red. The WUE LED on the MSII stays lit then too, can be reset by powering off and powering on, stays off till the RPMs are raised then the previous pattern repeats.
Looks to me like everything is working? Any other checks to run at this time?
(Boy, the voltage sure drops when I "rev" it up! Hits the 9-10volt range and stays there till I back off the "throttle".)
The WarmUpEnrichment guage is a bit wonky...... keeps dropping till it goes off the chart and goes red. The WUE LED on the MSII stays lit then too, can be reset by powering off and powering on, stays off till the RPMs are raised then the previous pattern repeats.
Looks to me like everything is working? Any other checks to run at this time?
(Boy, the voltage sure drops when I "rev" it up! Hits the 9-10volt range and stays there till I back off the "throttle".)
Comment