Sometimes it boggles my mind when folks start cutting and hacking and rigging up electrical systems in their projects, only to find out that the solution to their problem or dilemma was right in front of them all along. I know I’ve found myself contemplating additional wiring before, only to find out that it was already built into the main wiring harness of the car. Sometimes it is best to take a breath and make sure of what you are doing before going off half cocked. The Holley EFI Power Tap is one of those solutions that folks sometimes don’t realize exists. The Power Tap is a simple and easy way to provide power, ground, signals, etc for additional sensors in your Holley EFI install.
But it’s not just the race stuff that has it, you get the Power Tap with all the systems, and the video below will explain why you care and how to use it.
Video Description:
Adding sensors or accessories to your Holley EFI, Terminator X, or Sniper EFI system? Don’t cut or splice your main wiring harness. The Holley EFI Power Tap is a factory-built solution that gives you clean access to 12V switched power, 5V reference, chassis ground, and sensor ground, all without hacking into your harness.
The Power Tap makes it easy to wire in flex fuel sensors, dome pressure sensors, alternator exciter wires, and other EFI accessories while keeping your install clean, reliable, and factory-looking. Designed for low-current devices or relay triggers, it helps reduce electrical noise, voltage drop, and future troubleshooting headaches.
If you want a professional EFI install that works right the first time, the Power Tap is the way to go. Learn more about Holley EFI systems at Holley.com.
