When things aren’t going right, you just go all in right? That’s what Brent and Karl are doing on the ramp truck! It’s got some issues, but they think they can fix them in the videos below. And then some other issues pop up. So what the hell are they going to do since they are supposed to drive this thing 4500 miles across Canada? Roll with it baby!
In the last couple of episodes of this build they installed the ramp and deck and did some other cool stuff, and this thing is really close to being done. Done enough that they are planning a big road trip with it, so watch this!
This project has been a fun one to watch, it started when Brent from Halfass Kustoms and Karl from Make It Kustom got together to make Karl’s ramp truck project into an LS swapped and air ride equipped cab and chassis in just a few days. Their goal for this project was to make it run and do a burnout before Brent had to go back home to Manitoba. It’s a lot to do in just 4 days, but they made it happen! But a lot has happened since then!
That’s right, just 4 days to get the cab mounted and the tilt function working, fabricating and installing an entirely new steering system, mounting and installing the engine and transmission, cooling system, engine wiring, cab wiring, cutting the rear chassis and installing a step notch and full fabricated 4-link suspension system, and so much more.
Check it out below and make sure you comment in the comments section below with what you think about this cool project.
