Testing A Twin Turbo Mustang On The Street In Preparation For Asphalt Wars !
Ah the good old street test session. These usually go one of two ways, you either find a spot that you can hang out at all night and make run after run or you find a great spot and get chased off in...
Car Show Coverage: Our Final Gallery From Hot Rods On The Tarmac And Santa Ana Drags Exhibit At Lyon Air Museum
Our final gallery of photos from the Lyon Museum is below, but if you missed the previous photos then use the link below to check them out too. This is a special show that features some awesome hot...
New Product Spotlight: Tim McAmis Talks About Their Fabricated Axle Housing Blanks. Anyone Can Build A Bitchin Rear With This Setup!
Building a badass custom fabricated rear end for your race car has never been easier thank to the gang at Tim McAmis Race Cars, who have a bitchin Fabricated Sheet Metal housing that is ready for you...
Car Show Coverage: Hot Rods On The Tarmac And Santa Ana Drags Exhibit At Lyon Air Museum
Our second gallery of photos from the Lyon Museum is below, but if you missed the previous photos then use the link below to check them out too. This is a special show that features some awesome hot...
WHICH LS HEADS MAKES MORE HP? PORTED REC PORT OR CATHEDRAL PORT? TFS 245 VS TFS 255 ON 427 STROKER
The Rectangle Port vs Cathedral Port argument in the LS engine world is as fierce as the Rectangle Port vs Oval Port argument that has been going on for decades in the Big Block Chevrolet world. But...
If You Bought The Squares You Use For Welding At The Hardware Store, You Are Doing It Wrong. Watch To See How.
I’ve talked about the squares that I own from Fireball Tools on a few occasions, and have had mine for years. I even have some of their old weld-together steel squares that you could buy in kit...
Car Show Coverage: Hot Rods On The Tarmac At Lyon Air Museum 2023, Plus The Santa Ana Drags Exhibit!
(Photos by Wes Allison) Hot Rods and Airplanes go hand in hand and this show at Santa Ana’s Lyon Air Museum has them sitting side by side yet again. We loved sharing this show with all of you last...
Polishing Turds Season 2: Part 4 – Truing Up The Decks On Cody’s ProCharged 360 Cubic Inch Small Block To Make Big Power!
In the fourth episode of this new Polishing Turds engine project, Pete is going to be making the decks perfectly square and flat so this little supercharged small-block will make more power. This is...
FREE LIVE STREAMING DRAG RACING: The Jim Sweet Memorial Old School Bracket Race At Crossville Dragway
The 2nd Annual Jim Sweet Memorial Bracket Races are on this weekend. This is a great race, held over two days, that features great payouts and best losing package prizes in every round. They call...
Free LIVE Streaming Drag Racing: ACE Ohio Events Summit Fall Slam – Saturday
We’ve got free live streaming video from the Summit Fall Slam all weekend long thanks to our partners at DragRacerTV. Check out all the action right here all weekend long! If you want to see...
The Sniper 2 EFI From Holley Just Dropped And Here Is The Install Guide! Making EFI The Easiest And Best Yet.
Holley is back at it with a whole new Sniper EFI system! The new Sniper 2 is a whole new animal with more features, easier installation, better hardware, and more! Holley says they have taken the #1...
More NHRA Drag Racing Photos: THE FINAL NHRA NATIONAL EVENT AT BANDIMERE SPEEDWAY. NHRA MILE-HIGH NATIONALS PHOTOS
Here’s our last gallery of photos from Bandimere’s final NHRA National Event that was held last weekend, and if you missed the first couple we’ve got a link below for those too!...
NHRA Drag Racing Photos: THE FINAL NHRA NATIONAL EVENT AT BANDIMERE SPEEDWAY. NHRA MILE-HIGH NATIONALS PHOTOS
(Photos by Kim Fuller) This weekend was the final Mile High Nationals at Bandimere Speedway and thanks to Kim Fuller we’ve got a few galleries of photos from this iconic event. We race at...
