On 3/06 We Honor The 306ci Ford – A Small Block Made Better by Hot Rodders
There are certain engine combinations that are so prevalent in the world of hot rodding we’re wondering why the original equipment manufacturer did not just build them itself to start with. One...
New Product: Holley Steering U-Joints and Double “D” Steering Shafts for Your Custom Vehicle
If you are building a custom vehicle, whether it is a street rod, custom truck, or muscle car, there are times when an aftermarket steering column and steering shafts are a much better solution than...
TIG Welding Basics With Karl From Make It Kustom – SIMPLE Tips & Tricks How to Get Started
I watch all of Karl Fisher’s videos, because his YouTube Channel “Make It Kustom” is all about shaping metal and I dig it. But there is also a lot on the channel about welding, and...
New Product: Holley Easy Level™ Floatless Fuel Level Sending Unit
Yep, you read that right, this is a fuel level sending unit that has no float. It uses the latest tech in the form of LiDAR. And in truth, it can be used for many different fluid levels, and we...
The Fab Forums Fox Body Project: Doing A Factory Mini Tub Build Part 3
Watch Part 3 of the mini tub install now. In the previous installments, Kyle put together a cool tube front end that replaces all the inner bumper and chassis structures, and then he built a bad ass...
New Product, And How To Assemble It: The Speedway Motors Sheet Metal Mock Up LS Engine!
If you haven’t seen Speedway Motors new sheet metal, bolt together, LS mock up engine block, you are in for a treat. And sources close to the project say that there are small block and big...
Good Gravy: Ride On This GSXR600 Hill Climb Bike Running 100% Nitromethane! Insanity!
The demonic combustion properties of nitromethane fuel are mostly shown off in the world of drag racing but there are other motorsports that tip the can and tip the can hard. Motorcycle hill-climbing...
Tool Review: Is This Hand Tool The Budget Solution For LARGE WIRE CRIMPING?
Very often we find ourselves working on a project wishing we had some fancy tool that would make life much easier. Unfortunately, those fancy tools usually cost a lot of money so you don’t buy...
New Tri-Five Chevy Parts: Bolt-In Underdash Hydraulic Clutch System From American Powertrain
Tri-Five owners rejoice! American Powertrain is not only the place for no fabrication needed 5 and 6 speed manual transmission conversions but also the place for full hydraulic clutch retrofit...
Can You Reuse Rod And Main Bolts? Torque To Angle And Torque To Yield, Everything You Need To Know About Fasteners On Gen V GM Engines
I remember building some of my first engines, using parts we had in the garage, which included used rod bolts, main bolts, and head bolts. We weren’t building big power combos, or things under...
How To Build A Chassis Table That Will Fit In Any Garage!
Every hot rodder that does any kind of fabrication has at some point drooled over a killer welding fixture table or chassis table. We all have, even when most of us have no room for that kind of...
New Product: Hurst Direct Fit Roll/Control Line/Loc Kits For GM F-Body And GM G-Body
For some reason, there are so many hot rodders, pro-touring enthusiasts, and street car owners who think that a Line Loc, or Roll Control, is something only drag racers need. Sure, they were...
Save Up To 86% During Holley’s Winter Blowout Clearance Sale
Man are there some deals right here! Holley has tons of parts on sale now to make room for new inventory! If you have been waiting for a deal on the right parts, then this just might be the time....
